Decal consists of 3 layers: back paper layer, decal layer and transfer tape layer.
Do not apply wall decals to freshly painted walls! Wait a minimum of 2 weeks after painting. Don’t forget that vinyl wall decals are removable although not reusable so be careful when selecting the place where you want your decal to be.
You will need scissors, tape, pencil, measuring tape, credit card or book with hard cover, rag and water cup.
Step 2.
Take a measuring tape and measure place where you want your decal to be. Lay decal to the wall and make marks on 
the surface with a pencil and make sure that the marks are alight correctly horizontally and vertically.
the surface with a pencil and make sure that the marks are alight correctly horizontally and vertically. Step 3.
After you prepared your surface try out our sample-test decal following the steps 4-12. If you are sure that you understand wall all the steps you can start to apply main decal.
Roll out decal. If you notice that you have some air bubbles between your decal layer and decal transfer tape layer remove them by rubbing on decal with your credit card, book or fingers (do it also on a hard flat surface such as table). If there are some left – no problem, later you will repeat procedure again.
Now, slowly lift transfer tape layer of decal, starting from any corner of decal, from the back paper layer – but don’t separate transfer tape layer completely just do a half of it. Check if decal is sticking to the transfer tape layer.
If you decal doesn’t sticks to the transfer tape layer as shown on image 5, rub it with your credit card, book or fingers again (image 6).
Now, slowly separate transfer tape layer with decal on it starting from the corner from the back paper layer. Make sure that all parts of decal are sticking to the transfer tape layer before you completely separate decal and transfer tape layer from the back paper layer. Only separate transfer layer completely if you are sure that ALL ELEMENTS of decal ARE sticking on the transfer tape layer.
In case you realized there are some parts of decal are missing slowly put back decal layer and transfer tape layer to back paper layer. Rub on again all layers with your hand, credit card or book and again slowly lift transfer layer. Now, decal layer should stick to the transfer tape layer.
After you lifted your decal by transfer tape layer from the back paper lay the corner of your wall decal (corner of transfer tape layer where NO DECAL is) to the mark on the surface you made before. Ask someone to help you hold the decal with detached from the surface. Stick upper corners with the tape.
Step 10.
Ask someone to help you to hold the rest of decal so it will not stick to the surface. Now start slowly from the top left corner to stick decal to the surface. Rub decal with credit card, fingers or book for all air bubbles to disappear.
Now peel slowly the transfer tape from the decal. All decal’s part should stick on wall.
After you separate transfer tape layer from decal and stick you decal to the surface, remove all the air bubbles (if there are any) again with your credit card. You can now clean wall decal with the wet rag or any other soft peace of material. That is all!
Thank you for choosing Wall’s Tale Wall Decals! We hope you enjoy it!
**Warning** CHOCKING HAZARD. Keep out of reach of children. Children may be able to peel small pieces of vinyl off the wall. Do not hang in areas where small children are able to reach.
